通常在建筑工地的圖顏色鋁板,其性能是使它被廣泛使用,但是也有一個好的外表,但著色過程中可能不是容易的顏色,這就要求員工及時檢查觀察問題的流程步驟。
　　Usually in the construction site, the drawing color aluminum plate, whose performance is to make it widely used, but also has a good appearance, but the coloring process may not be easy color, which requires employees to check and observe the process steps of the problem in time.
　　1.可能是由于陽極氧化膜厚度不足，需要檢查陽極氧化過程是否規范，溫度、電壓、電導率等因素是否穩定。如有異常，應及時調整。

　　1. It may be due to the insufficient thickness of anodizing film, it is necessary to check whether the anodizing process is standardized, and whether the temperature, voltage, conductivity and other factors are stable. In case of any abnormality, it shall be adjusted in time.
　　2.也可能是由于染料溶液的pH值過高，可以用冰醋酸來調節pH值至標準值。
　　2. It may also be that the pH value of dye solution is too high, so glacial acetic acid can be used to adjust the pH value to the standard value.
　　3,或者因為顏色鋁板氧化在水箱放置太久時間可以主張在這個時候及時染色但現狀可以放置在陽極氧化槽或硝酸中和槽后適當的激活染色效果會很好。
　　3. Or because the color aluminum plate is oxidized in the water tank for too long, it can be claimed to dye in time at this time, but the current situation can be placed in the anodizing tank or nitric acid neutralization tank after the appropriate activation dyeing effect will be very good.
　　4.染料選擇不當，染料已被分解或發霉需要更換合適的染料。
　　4. The dye is improperly selected, the dye has been decomposed or moldy, and the appropriate dye needs to be replaced.
　　5.氧化溫度過低容易造成皮膜密度過高，可適當提高氧化溫度。
　　5. If the oxidation temperature is too low, the density of the film will be too high, and the oxidation temperature can be increased properly.
　　如果彩色鋁板不能著色的現象可以按照以上步驟進行檢查，而且你不能隨意改變方法，這樣可能會導致顏色失效，不能使用浪費等情況。
　　If the color aluminum plate can't be colored, you can check according to the above steps, and you can't change the method at will, which may lead to color failure and waste.
　　以上是鋁板生產廠家為大家介紹的相關內容，想要了解更多內容，歡迎訪問網站：http://m.kangyanghua.com
　　The above is the relevant content introduced by the aluminum plate manufacturer for you. To learn more, please visit the website: http://www.jndclyxgs.com